Design:
-Tooth configuration: TC2
-Cutting material: TC
-Expansion slots: Cu plugged

Application:
-For fine sizing cuts in single or double laminated panels, plexiglass and solid surface materials such as Wilsonart Gibraltar, SSV; Corian; Surell; Avonite; Fountainhead, etc.
-On table saws, sliding table saws, radial arm saws and vertical panel sizing saws
-"Non-Melt" saw blades see LNM series

Design:
-Tooth configuration: refer to chart below (grind)
-Cutting material: TC
-Expansion slots: Cu plugged
-Very stable body minimizes run-out

Application:
-For fine cross cuts in veneered panels, expensive woods and sheets, thin plexiglass, masonite and plastics
-On table saws, sliding table saws and vertical panel sizing saws

L04302- Altendorf, Omga, SCMI, Striebig

Design:
-Tooth configuration: ATB
-Cutting material: TC
-Expansion slots: Cu plugged
-Thin rimmed body (on left side) allows for thin kerf at teeth and stability during cutting operation

Application:
-For fine cross cuts in veneered panels, expensive woods and sheets, thin plexiglass, masonite and plastics
-On table saws and sliding table saws

Collar width 2"

Design:
-Tooth configuration: TC2
-Cutting material: TC
-Expansion slots: Cu plugged
-Thin rimmed body (on left side) allows for thin kerf at teeth and stability during cutting operation

Application:
-For fine cross cuts in acrylic sheets, thin plexiglass, masonite and plastics
-On table saws and sliding table saws

Collar width 2"

Design:
-Tooth configuration: TC2
-Tooth geometry specifically designed to minimize "melting" of material
-Cutting material: TC
-Expansion slots: Cu plugged

Application:
-For "non-melt" fine cross cuts in acrylic sheets, selrins, ABS (cycolac), Styrenes and PVC
-On table saws, sliding table saws and vertical panel sizing saws

LNM220- Holz-Her