Design:
-Tooth configuration: refer to chart below (grind)
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For cross cutting solid wood, veneered and plastic laminated sheets
-On portable machines

LH424, LH426, LH440, LH442-For Porter cable, Makita, supplied with reducing bushing for 3/8" arbor
LH530- For Makita and others, supplied with reducing bushing for 1/2" and 10mm arbors

Design:
-Tooth configuration: TCGN
-Cutting material: TC
-Modified grind and 15 degree negative hook reduces the possibility of tooth damage

Application:
-For rough cutting applications
-On gasoline powered machines

Note: Due to the rough applications for which these blades may be used, the are not guaranteed

Design:
-Tooth configuration: refer to chart below (grind)
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For ripping and general cross cutting dry solid woods
-On portable machines and table saws

LH624, LH708, LH712, LH724, LH726, LH824- Diamond arbor knockout

Design:
-Tooth configuration: refer to chart below (grind)
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For cut-off and trimming of solid woods, plywood and plastic laminated sheets
-On portable machines and table saws

LH640, LH740, LH742, LH840, LH842- Diamond arbor knockout

Design:
-Tooth configuration: refer to chart below (grind)
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For fine cut-off and trimming of solid woods, plywood, wood veneered and plastic laminated panel materials
-On portable machines and table saws

LH860, LH862- Diamond arbor knockout

Design:
-Tooth configuration: 4 ATB and 1 Raker
-Cutting material: TC
-Four ATB teeth and one Raker with deep gullet allow for deeper cuts and improved chip-flow

Application:
-For cross cutting and ripping dry soft and hardwoods, plywood and particleboard
-On portable machines and table saws

LH407, LH408- Diamond arbor knockout

Design:
-Tooth configuration: 4 ATB and 1 Raker
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For mitre joint cuts in soft and hardwood picture frames and furniture mouldings
-On cut-off mitre machines, compound mitre machines, radial arm saws and table saws

LH864- Black & Decker Mitre, Delta Compound Mitre, Ryobi Radial Arm
LH863- Elu Mitre, Hitachi Mitre

Design:
-Tooth configuration: High ATB (30 degree)
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For chip-free sizing cuts (on both sides) in melamine and wood veneered panels, without the need for pre-scoring
-For fine cross-cuts in solid woods
-On table saws, sliding table saws, vertical panel sizing saws and cut-off saws

Design:
-Tooth configuration: TCG
-Cutting material: TC
-Expansion slots: laser, self plug

Application:
-For splitting and mitre jointing non-ferrous extrusions, thin sheets and light non-ferrous bars
-On mitre and compound mitre saws
-Material to be cut must be clamped firmly
-Use of spray lubrication recommended

LH743- Diamond arbor knockout
LH866- Black & Decker Mitre, Delta Compound Mitre, Ryobi Radial Arm
LH868- Elu Mitre, Hitachi Mitre